Which dashboard warnings should absolutely not be ignored?

Modern cars are literally stuffed with electronics, which monitor various parameters of the engine, warning the driver about the presence of certain problems with the gearbox, engine or any other units and assemblies in the car. Let’s talk in detail about what warnings on the dashboard should not be ignored, because this can lead to serious malfunctions of the car. But if the car is already broken and its repair will cost a lot of money, then it is better to give the car for recycling: https://towingandscrapcarremoval.ca.

What warnings on the dashboard should not be ignored categorically?

Engine overheating
The engine cooling system has a special sensor that registers the temperature of the coolant and the engine itself. If the engine temperature exceeds the thresholds, the corresponding lamp lights up on the dashboard, the appearance of which should not be ignored. The main causes of engine overheating are loss of coolant, fan malfunction, thermostat or water pump breakdowns. If such breakdowns occurred on the road, the driver should stop, wait for the engine to cool, then call a tow truck and take the car to service. Keep in mind that if you continue driving or trying to get to a workshop on your own, this may lead to engine overheating and critical engine malfunction, which can only be repaired by an overhaul.

Oil pressure warning lamp
The correct operation of the engine and the absence of its critical breakdowns will largely depend on the proper functioning of the lubrication system. If for any reason the oil in the engine has high or insufficient pressure, this can lead to critical engine malfunctions. The cause of low oil pressure can be a leak in the oil circuit, insufficient oil in the engine, pump malfunction or bearing damage. It is strictly forbidden to continue driving the car with the oil pressure check lamp lit, because in such a case the driver risks serious engine damage.

What not to ignore from dashboard alarms

The signal of insufficient battery charge
Typically, this insufficient battery charge light comes on when there are malfunctions in the alternator, after which it no longer charges the battery. The alternator recharges the battery while the vehicle is in motion, and the subsequent electric current from the battery is used to start the engine. If the alternator fails, eventually a complete discharge of the battery is noted, and this can lead to a rapid reduction in the service life of the battery. The battery charge warning light on the dashboard may indicate a broken alternator, timing belt rupture, or problems in the electrical circuit. In such a case, the vehicle should be diagnosed, after which the existing malfunction can be determined and repaired.

If a brake fluid warning light is illuminated
This warning light may illuminate if the pads are worn, the brake fluid is low, or leaks. Remember that safety regulations strictly forbid you to continue driving with the brake line warning light illuminated, as this will invariably result in complete failure of the brakes, and most often lead to serious accidents. It will be necessary to stop slowly on the roadside, switch on emergency lights and call a tow truck to take the car to a garage or service.

To summarize.
While operating a car, a car owner must remember that it is strictly forbidden to ignore and continue driving when the control lights of the battery discharge, insufficient pressure in the brake line, engine overheating and oil pressure are lit. In such case the driver risks not only to get in an accident, but also serious car breakdowns, which can be eliminated only by complicated and expensive overhaul.

Leave a Reply

Your email address will not be published. Required fields are marked *